Arduino Quiz – How much do you know about Arduino?
-
What is Ardiuno?
-
Coding Environment (IDE)
-
Hardware (Microcontroller)
-
Code (Arduino Code)
-
All the above
-
-
Which is the Arduino Board with most number of Pins?
-
Arduino Nano
-
Arduino Lillypad
-
Arduino Mega 2560
-
Arduino MKR 1000
-
Arduino Stamp
-
-
What does IDE in Arduino IDE Stands for?
-
Internal Development Environment
-
Integrated Development Environment
-
Integrated Drive Electronics
-
Internal Device Electronics
-
-
Which type of pins can be used to control Servo Motors?
-
All GPIO Pins
-
Analog Pins
-
All Digital Pins
-
Digital Pins with PWM Out
-
UART Pins
-
-
What is the full form of GPIO
-
General Purpose Internal Object
-
General Purpose Input Output
-
General Practice Internal Operator
-
Grand Programmer Initial Order
-
Grub Push Identifier Omitter
-
-
The process of conversion of an Arduino Sketch we write to instructions the microcontroller understand is known as –
-
Coding
-
Running
-
Execution
-
Uploading
-
Compiling
-
-
In the case of Arduino UNO, which pin is connected internally to the onboard LED?
-
Pin 13
-
Pin 6
-
Pin 11
-
Pin 10
-
Pin 2
-
-
Is it possible to create our own Arduino Board?
-
Yes
-
No
-
-
What is the value of Crystal Oscillator in Arduino UNO?
-
20 KHz
-
4 MHz
-
16 Mhz
-
1024 Khz
-
700 Mhz
-
-
What are Arduino “Shields”?
-
Shields are protective covers to prevent Arduino from physical damage.
-
Shields are water/fire resistant ceramic coating for Arduiino
-
Specialized boards with a particular function where you can connect your Arduino.
-
A Hard covering held by straps or a handle attached on one side, used as a protection against blows or physical stress.
-
-
What are the lines starting with “//” called?
-
Function
-
Slasher
-
Class
-
Comments
-
Slash line
-
-
From which language was the Arduino Programming Language derived from?
-
C/C++
-
Java
-
Python
-
GoLang
-
Swift
-
-
What are the two basics functions used while programming an Arduino Board?
-
delay() & start()
-
delay() & execute()
-
start() & finish()
-
loop() & setup()
-
digitalread() & analogread()
-
-
How to get analog values from an analog pins?
-
analogRead()
-
analogWrite()
-
analogSweep()
-
digitalRead()
-
Serial.read()
-
-
How to get PWM (Pulse Width Modulated) output from digital pin?
-
Using analogWrite() on any Digital Pin
-
Using analogWrite() on any Analog Pin
-
Using digitalWrite() on any Analog Pin
-
Using analogWrite() on PWM Digital Pin
-
Using pwmWrite() on PWM Pins
-
Leave your vote
This post was created with our nice and easy submission form. Create your post!